Installation Sheet

3. Install the Spout
NOTICE: The brass collar with O-ring included in the hardware
bag is not needed for this installation. Please discard the brass collar
with O-ring.
Insert the remaining O-ring into the groove in the underside of
the escutcheon.
Thread the nut all the way down the diverter valve.
Insert the diverter valve into the mounting hole from underneath.
Thread the escutcheon down the diverter valve until it stops.
Wrench tighten the nut to secure the diverter valve.
Use a needle-nose pliers to lift and hold the diverter tube. Then
thread the lift rod into the diverter tube.
Ensure that the setscrew does not protrude beyond the inside
wall of the spout. Back the setscrew out if needed.
IMPORTANT! Do not bend the lift rod during spout installation.
Position the spout over the lift rod, and slide it down onto the
diverter valve.
Tighten the setscrew.
Insert the plug button into the setscrew hole.
Setscrew
Plug Button
Lift Rod
Diverter
Tube
Nut
Diverter Valve
O-Ring
Escutcheon
1276522-2-A 6 Kohler Co.