Installation Manual

3. Install the Soap Dish
Slide a nut onto the soap dish post assembly.
From the top of the faucet, insert the soap dish post assembly
into the hole at the base of the spout. Tighten until secure.
Place the soap dish on the top of the soap dish post assembly.
For an installation without a soap dish:
Install the spout post cap into the hole at the base of the spout.
Tighten until secure.
4. Installation Checkout
Ensure that all connections are tight.
Open the drain.
Turn on the main water supply.
Twist the aerator counterclockwise until it is removed from the
spout.
Open both hot and cold valves.
Run water through the spout for approximately one minute to
remove debris. Check for leaks.
Remove any debris from the aerator and reinstall.
Soap Dish
Soap Dish
Post Assembly
Spout Post Cap
Kohler Co. 5 1015158-2-C
Foraninstallationwithasoapdish: