Specification

Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
62-1/2″ (1588 mm) x 24-3/4″ (629 mm)
Basin area, top 49″ (1245 mm) x 22″ (559 mm)
Weight 400 lbs (181.4 kg)
To overflow:
Water depth 19″ (483 mm)
Capacity 75 gal (284 L)
* Approximate measurements for comparison only.
Drop-in cut-out 66-1/2″ (1689 mm) x 31″ (787 mm)
Blower
motor:
kW V Hz A
300 220-240 50/60 3
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor/control 220-240 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are
relocated, two access panels are required. Locate one
access panel at the blower motor/control location and the
other at the control box. Locate the blower motor and check
valve together.
Floor support under bath must provide for a minimum of 78
lbs/square foot (386 kg/square meter) loading.
Splitting the deck/surround is recommended if installing into a
deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to ASME Standard A112.19.1/CSA B45.2. All
dimensions are nominal.
NOTE: Blower protrusion
beyond the rim.
Blower Motor/
Control Access
34" (864 mm) W x
15" (381 mm) H
2-1/2" (64 mm)
14-1/2"
(368 mm)
31-1/2"
(800 mm)
1-3/16" (30 mm)
19-1/16"
(484 mm)
17-3/8"
(442 mm)
22-3/16" (564 mm)
4"
(101 mm)
No change in measurements if connected
with drain illustrated. (K-7272)
1-1/2" PVC
2-1/2"
(64 mm)
7"
(178 mm)
2-5/8" (67 mm)
10-1/8"
(258 mm)
2-7/16"
(62 mm)
66-15/16" (1700 mm)
33-1/2" (851 mm)
Product Diagram
REVETM
REVETM BUBBLEMASSAGETM BATH
Page2of2
1146921-4-
B