Installation Guide

2. Install the Remote Dock
Position the remote dock at the desired mounting location.
Confirm that the remote dock is level.
Using a pencil, mark the two mounting-hole locations. Set the
remote dock aside.
For installation into a stud or other wood surface: Drill a 1/16″
hole at each of the marked locations.
For installation using wall anchors: Drill a 1/4″ hole at each of
the marked locations. Install the provided wall anchors into the
holes.
Position the remote dock over the anchors or marks. Secure the
remote dock with the provided screws.
Open the battery compartment on the remote control. Install the
four provided AA batteries.
Position the remote control on the remote dock.
1/16"
or 1/4"
Holes
Remote Dock
Remote Control
Batteries
1341257-2-A 6 Kohler Co.