Rough-In Guide

Product Information
Applicable products:
5.5’ bath whirlpool, custom pump location K-856-HE
5.5’ bath whirlpool, custom pump location K-856-HN
Fixture*:
Bathing well:
Basin area 45″ (114.3 cm) x 25″ (63.5 cm)
Top area 58″ (147.3 cm) x 29″ (73.7 cm)
Weight 510 lbs (231.3 kg)
To overflow:
Water depth 19-1/2″ (27.3 cm)
Capacity (to overflow) 105 gal (397.5 L)
* Approximate measurements for comparison only.
Pump kW V A*
1.5 240 11
* Approximate measurements for comparison only.
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Cast iron whirlpools are extremely heavy, making some
drop-in installations difficult. Splitting the deck/surround is
recommended if installing into a deck.
Floor support under whirlpool must provide for a minimum of
86 lbs/square foot (418 kg/square meter) loading.
A pump/control access panel is required.
For a drop-in installation, the cut-out dimension is 64-1/2″
(163.8 cm) x 34-1/2″ (87.6 cm).
For an undermount installation, the K-587 template is
required.
The hot water supply should be 70% of capacity or greater.
Installations will vary.
The pump must be relocated to a custom position at the time
of installation. Provide adequate clearance.
Fixture conforms to ASME Standard A112.19.1. All dimensions
are nominal.
6-1/2" (16.5 cm) Max
9" (22.9 cm)
Max
15-7/8"
(40.3 cm)
66" (167.6 cm)
36" (91.4 cm)
24"
(61 cm)
1-1/2" OD
18"
(45.7 cm)
4-3/16"
(10.6 cm)
2-7/8" (7.3 cm)
1/2" (1.3 cm)
3" (7.6 cm)
3/4" (1.9 cm)
K-856-HE
Pump/Control Access
34" (86.4 cm) W x 15" (38.1 cm) H
K-856-HN
Pump/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
No change in measurements if connected with
drain illustrated. (K-7147-AF or K-7147M-AF)
Roughing-In
K-856-HE, K-856-HN
TEA-FOR-TWO
®
5.5’ CUSTOM BATH WHIRLPOOL
TEA-FOR-TWO
®
5.5’ CUSTOM BATH WHIRLPOOL
1019483-1-
D