Rough-In Guide

Product Information
Applicable products:
6’ bath whirlpool, custom pump K-865-HB
6’ bath whirlpool, custom pump K-865-HD
6’ bath whirlpool, custom pump K-865-HM
Fixture*:
Bathing well:
Basin area, bottom 49″ (124.5 cm) x 22″ (55.9 cm)
Basin area, top 62″ (157.5 cm) x 28″ (71.1 cm)
Weight 455 lbs (206.4 kg)
To overflow:
Water depth 17″ (43.2 cm)
Capacity 89 gal (336.9 L)
* Approximate measurements for comparison only.
Pump kW V A*
1.5 240 11
* Approximate measurements for comparison only.
Drop-in cut-out 70-1/4″ (178.4 cm) x 34-1/2″ (87.6 cm)
Included component:
Cut-out for undermount K-582 template
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD):
Pump/control 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
69 lbs/square foot (333 kg/square meter) loading.
Cast iron whirlpools are extremely heavy, making some
drop-in installations difficult. Splitting the deck/surround is
recommended if installing into a deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Pump must be relocated to custom position at the time of
installation. Provide adequate clearance.
Fixture conforms to ASME Standard A112.19.1. All dimensions
are nominal.
9" (22.9 cm)
Max
5" (12.7 cm) Max
15-5/8"
(39.7 cm)
71-3/4" (182.2 cm)
36" (91.4 cm)
20-7/8"
(53 cm)
1-1/2" OD
18"
(45.7 cm)
3-1/2"
(8.9 cm)
2-1/2"
(6.4 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
1/4" (6 mm)
3/4" (1.9 cm)
7" (17.8 cm)
Max
K-865-HD
Pump/Control Access
34" (86.4 cm) W x 15" (38.1 cm) H
K-865-HB
Pump/Control Access
34" (86.4 cm) W x 15" (38.1 cm) H
K-865-HM
Pump/Control Access
34" (86.4 cm) W x 15" (38.1 cm) H
No change in measurements if connected with drain
illustrated. (K-7169-AF or K-7169M-AF)
Roughing-In
K-865-HB, K-865-HD, K-865-HM
TEA-FOR-TWO
®
6’ BATH WHIRLPOOL
TEA-FOR-TWO
®
6’ BATH WHIRLPOOL
1019454-1-
D