Installation guide

2. Install the Showerhead Assembly
CAUTION: Risk of product damage. To avoid clogging the
showerhead spray outlets, use thread sealant tape on the
shower arm threads. Do not use thread sealant compound
(pipe dope).
Remove the temporary nipple from the shower elbow.
Apply thread sealant and install a 1/2″ NPT nipple to extend
1/2″ (1.3 cm) beyond the finished wall.
Apply a bead of plumbers putty or other sealant to the back of
the shower arm. Refer to the putty or sealant manufacturer’s
instructions for proper application.
Apply thread sealant tape to the pipe nipple and thread the
shower arm onto the pipe nipple.
Carefully tighten the shower arm to the pipe nipple with a clean
strap wrench.
Remove all excess putty.
With the showerhead off, flush out the system.
Apply thread sealant tape to the shower arm, and thread the
showerhead to the shower arm.
1/2"
(1.3 cm)
1/2"
Nipple
Apply plumbers putty.
Kohler Co. 5 1031652-2-C