Installation Guide

3. Install the Spout
Thread the nut all the way down the diverter valve.
Insert the diverter valve into the mounting hole from underneath.
Thread the brass collar with the O-ring down the diverter valve
until it stops.
Wrench tighten the nut to secure the diverter valve.
Use needlenose pliers to lift and hold the diverter tube. Then
thread the lift rod into the diverter tube.
Ensure that the setscrew does not protrude beyond the inside
wall of the spout. Back the setscrew out if needed.
Setscrew
Brass
Collar
Lift Rod
Diverter
Tube
Nut
Diverter Valve
O-Ring
Plug Button
1330094-2-A 6 Kohler Co.