Installation Guide

5. Connect the Plumbing
NOTE: The illustration shown is a suggested plumbing connection
method. Actual plumbing connections will vary by site.
Verify that the spout, diverter valve, and remote valve are
properly positioned and secured.
Cut and assemble the copper tubing and connections to fit the
installation layout.
Install a vacuum breaker arrestor near the diverter valve inlet.
Follow the vacuum breaker arrestor manufacturer’s instructions.
Solder the connections.
Use thread sealant tape, and securely wrench tighten a cap to the
open inlet port of the diverter valve.
Vacuum Breaker
Arrestor
Cap
1330094-2-A 8 Kohler Co.