Installation Guide

2. Recess Mount - Construct the Framing

NOTE: The following instructions are for recess-mount only. For surface-mount installation, refer to the

″Surface-Mount″ sections.

Using a jigsaw or keyhole saw, carefully remove the ﬁnished wall material from the marked cutout.

Frame out the wall cavity. If needed, install a header.

IMPORTANT! Hole location in the framing is critical for electrical wire alignment with the cabinet. If you

plan to install an optional decorative surround, use the dimension speciﬁed for the cabinet plus surround.

For cabinet only installation: Mark the center of the hole 4-5/8″ (117 mm) from the bottom of the

cavity, and 2-5/16″ (59 mm) from the ﬁnished wall.

For cabinet plus surround: Mark the center of the hole 4-5/8″ (117 mm) from the bottom of the

cavity, and 1-7/8″ (48 mm) from the ﬁnished wall.

Drill a 3/4″ (19 mm) hole into each side of the framed cavity at the marked locations.

Cabinet Only:

2-5/16" (59 mm)

Cabinet + Surround:

1-7/8" (48 mm)

4-5/8"

(117 mm)

Ø 3/4"

(19 mm)

1337913-2-A 6 Kohler Co.