Installation Guide

2. Secure the Vanity
CAUTION: Risk of property damage. Select 250 lb (113.4
kg) load bearing 5/16″ lag bolts with a length to clear
obstacles in the wall and 5/16″ washers. Calculate proper lag
bolt length by adding the following: 1-1/2″ (38 mm) backing
material + wallboard thickness + back rail thickness.
With assistance, lift and place the vanity in position against the
finished wall. Do not drag the vanity into position.
Verify the vanity is level and plumb against the wall. If necessary,
turn the leveler(s) to adjust the unit.
Using a 1/4″ drill bit, drill pilot holes through the back rail and
the finished wall. Verify the pilot holes are positioned to ensure
the lag bolts will engage the 2x6 backing material or any studs.
Secure the vanity to the finished wall with two 5/16″ lag bolts
and washers (not provided).
Install optional accessories (shelves, drawers, other) as desired.
Refer to the instructions packed with the accessories.
Pilot Hole
Leveler
Washer
Lag Bolt
Back Rail
Kohler Co. 5 1216525-2-B