Owner's Manual

Shower Conﬁguration – Custom

IMPORTANT! For proper shower system setup and performance, especially regarding massage and spa

function, refer to the ″Shower Conﬁgurations – Overview″ section for important information.

NOTICE: Custom shower conﬁgurations may not allow certain system features to be enabled.

NOTE: Conﬁgurations other than the preprogrammed options will limit preprogrammed spa and massage

functions.

General Guidelines for Custom Conﬁgurations:

Outlet 1 is always recommended to be the primary showerhead. Custom mode will allow the user to select a

different port as the primary, but it is not recommended.

When cycling during massage functions, bodysprays/watertiles will cycle from Outlet 1 to Outlet 6,

regardless of which port is designated as the primary outlet.

The installer must determine the water outlet cycling order for the ″Single″ massage function and plumb

each water outlet accordingly.

Use the above diagrams to draw in the components for your custom shower.

Draw lines from the valve to each component as your shower is plumbed.

NOTE: Only water outlets designated as bodysprays or watertiles will be allowed to cycle. Any outlets

with 2 ﬁttings, such as 2 bodysprays or 2 watertiles will not cycle. Also any instance where watertiles and

bodysprays are used in the same conﬁguration, only the bodysprays will cycle.

Massage Options

•

Single

•

Wave

12 34 56CH

Water Outlet Configuration

Massage Cycling Patterns

1: Outlet 1 (Primary Showerhead)

2: Outlet 2

3: Outlet 3

4: Outlet 4

5: Outlet 5

6: Outlet 6

Single

Wave

= Constant on

= On while cycling

NOTE: Primary outlets and any outlets designated as

handshowers will not be included in the cycling pattern. For

installations that include both body sprays and watertiles, the

outlets designated as watertiles will not cycle.

1241234-5-A 18 Kohler Co.