Owner's Manual

Shower – Massage
Path: shower > massage
Function: activates the massage feature.
Factory default: off
NOTE: To see the [massage] icon on the shower screen, the feature must be enabled on the controller Web
pages, on both the ″System″ page, as well as the ″Valve″ page(s). To enable the massage feature, refer to
the ″Web Settings – System″ section and the ″Web Settings – Valve″ section.
IMPORTANT! For proper function, all shower fittings on the same valve that are enabled with massage
must have total equal flow rates. For example, if one valve outlet supplies water to two bodysprays, the
total flow rate of both bodysprays must equal the flow rate of a single fitting supplied by a different
outlet.
From the [shower] screen, touch the [massage] icon.
A pop-up window will appear showing massage options. If two valves are connected to the system,
the massage options are selected independently per zone.
The pop-up window displays massage cycling options (single or wave), and cycling speed.
Touch the [single] or [wave] option to set the massage function.
Single: Pulses rotate through the enabled shower fittings one at a time.
Wave: Pulses rotate through the all but one of the enabled shower fittings one at a time.
To change the cycling speed, touch [speed] or the triple arrows to the right. The number of
highlighted arrows indicates the speed setting (one arrow = slow, two arrows = medium, three
arrows = fast).
For a two-valve system, the massage options must be selected in the [zone 2] tab to activate the
massage feature on fittings connected to the second valve.
shower
home
massage
stop
target: 101˚
8:32am
massage options
zone 1 zone 2
single
wave
off
start
speed
shower
home
massage
stop
target: 101˚
8:32am
massage options
zone 1 zone 2
single
wave
off
start
speed
shower
home
massage
stop
target: 101˚
8:32am
101˚
zone 1 zone 2
stop
Kohler Co. 57 1241234-5-A