Owner's Manual

Download/Install Software
NOTICE: Software download and installation may take an hour or more to complete based on system
configuration and internet connection speed. Do not disconnect the power from any components during
software download and installation.
NOTE: Internet service is required to receive the latest updates for system components. The components
must be connected to the controller prior to software download.
Initial Download
Disconnect the power from the controller.
Make sure all system components are connected to the controller.
Connect the Ethernet cable from the controller to a router with active internet service.
Reconnect the power supply to the controller. The controller will communicate with the router to
receive an IP address.
Upon receiving an IP address, the controller will check for software updates for any connected
components, and will automatically download the updates. Do not disconnect the power from any
components during software download and installation.
Updates
The controller will check for software updates daily (around midnight), and will automatically
download and install if needed.
Software can be updated manually from the interface or the controller Web pages. For manual
update instructions, refer to the ″Software Updates″ section.
Internet
Service
Router
Ethernet Cable
Controller
AC
Power
Power Cord
To Digital Valve(s)
To Interface(s) and
Optional Components
1241234-5-A 6 Kohler Co.