Owner's Manual

Time – Bath Fill
Path: [time clock]
Function: turns water ON from the bath spout for a set period of time at the default temperature.
Factory default: ten minutes
NOTE: The [tub fill] option is only available on custom showers with a bath spout. During system setup in
the controller Web pages, the appropriate valve outlet must be assigned a bath spout icon.
Activate Bath Fill
Touch the time clock on any screen.
NOTE: The clock is located above the home screen icons, or at the right top corner of all other screens.
A pop-up window will appear showing the current time and three time-related options.
Touch the [tub fill] option.
To adjust the time duration, touch the up or down arrows. Minutes adjust sequentially. Seconds
adjust in 15-second increments.
Touch [start] to begin water flow from the bath spout.
If water was running from other fixtures: when [tub fill] is activated, the system shuts the other
outlets OFF. Water will flow only from the bath spout at the designated default temperature.
If water was not running from other fixtures: when [tub fill] is activated, water flows from the bath
spout, rising to the designated default temperature.
While [tub fill] is activated, a countdown clock appears in place of the time clock on all screens.
When the specified time period has elapsed, the pop-up window appears with the countdown clock
at zero, and the interface will beep every ten seconds.
The beeps cease after two minutes, or when the user touches [ok], [x], or the power icon.
Cancel Bath Fill
To stop water flow from the bath spout before the fill time as elapsed, touch [stop].
home
spa settingsstop
8:32am
stop
0 9 : 5 9
tub fill
alarm
minute timer
home
spa settingsstop
8:32am
start
1 0 : 0 0
home
spa settingsstop
ok
0 0 : 0 0
time elapsed
tub fill
alarm
minute timer
1241234-5-A 78 Kohler Co.