Owner's Manual

Software Updates
NOTE: The controller will check for software updates daily (around midnight), and will automatically
download the software. Software can also be updated manually from the controller Web pages.
From the Interface
From the [home] screen, touch the [settings] icon.
Go to [system], then to [updates].
A pop-up screen will indicate if updates are available for any connected system components.
From the Web Pages
On a computer or tablet connected to the same router as the controller, open a browser and enter
the Web IP address. To obtain the IP address, refer to the ″Initial System Setup″ section.
Click on the [Service] tab, then on [Updates].
Click [Check for Updates] to download the latest software for any connected system components.
If updates are available, the controller will automatically download the software.
Shower Configurations – Overview
NOTICE: Do not allow any outlet to flow more than 10 gal/min (37.9 l/min).
NOTICE: Custom shower configurations may not allow certain system features to be enabled.
Shower configurations are available based on the number of valves connected to the controller.
For optimum valve performance, the water heater should be set at 120°F (49°C). Hot water pressure
should be equal to or less than the cold water pressure.
Showering configurations using large water volumes require supply piping and drain systems that
will sufficiently accommodate the actual total flow rate at any one time.
Hot water generation: Use a water heating system capable of handling large flow rates. Tankless
(on-demand) water heaters and recirculating pumps may not be adequate for your showering
configuration.
Settings Service
Interface Web Pages
Diagnostics
Updates
Manual Update
Check for Updates
controller
ok
settings
system
updates
interface
update
Internet Update: Internet Connected
Upload
Choose File
File: XX
1241234-5-A 8 Kohler Co.