Installation Guide

2. Position the Bridge Cabinet
CAUTION: Risk of personal injury. Select 250 lb (113.4 kg)
load bearing 5/16″ lag bolts with a length to clear obstacles
in the wall and 5/16″ washers. Calculate the proper lag bolt
length by adding the following: 1-1/2″ (38 mm) backing
material, plus the wallboard thickness, plus the back rail
thickness.
IMPORTANT! Risk of product damage. Use care when moving the
bridge cabinet to avoid impacting, sliding, or side-loading the legs.
NOTE: The K-20199 bridge cabinet is designed to be installed with
the K-20195 vanity and is not intended to be installed individually.
Read both product installation instructions before beginning
installation. Install the vanity before the bridge cabinet.
Install Spacers (provided) – Only for Installation to a Vanity
IMPORTANT! Ensure spacers do not extend past the top front edge
of the bridge cabinet. Improper placement of spacers may interfere
with the installation of the stone top.
Remove the protective film from the adhesive strips on one of the
spacers.
Carefully position the spacer on the side of the bridge cabinet,
flush with the top and front edges.
Install a second spacer on the side of the bridge cabinet, flush
with the top and back edges.
Spacer
1304473-2-A 4 Kohler Co.