Installation Guide

5. Remove/Reinstall the Drawer
Remove
Slide the drawer out until fully extended.
From underneath, pull the release latches toward the center of the
drawer.
Lift the front of the drawer and pull toward you to disengage
from the rails.
Once removed, lay the drawer on a flat, protective surface.
Reinstall
Fully extend the rails.
Align the holes in the back of the drawer with the rail hooks.
Rotate the drawer down onto the rails, engaging the front drawer
holes with the rail pins.
From underneath, push the release latches into the rails to secure
the drawer.
Install the Knob
NOTICE: Ensure that the knob location you choose will provide
unobstructed clearance when opening and closing the door.
Select and mark the desired knob location on the door.
Use a 3/16″ bit to drill the marked hole location.
From the inside of the door, insert the screw through the hole.
Latch
Rail
Hook
Holes
Pin
Knob
Screw
1304473-2-A 8 Kohler Co.