Installation Guide

1. Install the Legs
IMPORTANT! Legs are not required for installation between two
vanities.
NOTE: To protect the finished surface of the cabinet, perform
assembly tasks on a flat, padded work surface.
Position the cabinet on a flat, padded surface.
Remove the drawer to access the holes for leg attachment. Refer
to the ″Remove/Reinstall the Drawer″ section of this guide.
Attach the Legs
For Installation to One Vanity Only: Determine whether the legs
will be installed on the left or right. The opposite side will be
supported when installed to the K-20195 vanity.
Position the cross rail above the clips in the front and back legs.
Press down firmly and evenly on the cross rail until it fully
engages into the clips.
Secure the leg assembly to the bridge cabinet using four #8 x 2″
panhead screws, lock washers, and flat washers (provided).
Kohler Co. 3 1304473-2-A