Installation Guide

22. Install the Outside Door Panel
NOTE: The rollers and the label face the outside of the shower.
Note the tape indicating the notch locations from the ″Measure and Cut the Headers″ section.
Remove the clamp from the tops of the panels.
With help, from outside the shower, lift the outside panel, align one roller with the notch in the
outer header, and set the roller on the roller track.
Lift the panel just enough to place the roller into one notch on the header. Then slide the panel over
so the second roller is aligned with the other notch in the header.
Verify that the bottom of the door panel is still in the centerguide channel.
Remove the corner protectors from the panels.
Make sure both panels move smoothly left to right.
Clamp
Tape
Kohler Co. 25 1380408-2-B