Installation Guide

3. Install the Centerguide
Measure the center of the threshold. Mark the centerline near the groove on the inside surface of the
threshold.
IMPORTANT! Drill through the inside surface only.
Drill a 1/8″ hole at the centerline on the groove of the inside surface of the threshold.
Install the centerguide clip to the threshold with the supplied #6 x 3/8″ screw.
Press the centerguide over the clip. Make sure the centerguide is completely installed with the tabs
snapped under the bottom of the threshold.
Inside
Surface
Tabs
Groove
1/8"
(3 mm)
Hole
1380408-2-B 6 Kohler Co.