Specification

Optional Accessories
88526 HiFlow Rite-Temp
®
thin wall installation kit ❑ CP ❑ Other __
1073881 Deep rough-in kit – for use with K-304-K,
K-304-KP, K-304-KS, and K-2971-KS
❑ NA
1092535 Deep rough-in kit for valves with push button
diverter – for use with K-11748-K and K-11748-KS
❑ CP ❑ BN ❑ SN
Installation Notes
Install this product according to the installation guide.
Install the Rite-Temp valve according to the installation guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install a shut-off device on
either valve outlet.
Cap the shower outlet if the deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install a 7″ (17.8 cm) to 18″ (45.7 cm) straight pipe or straight
tube with single bath elbow between the valve and the
wall-mount spout.
1/2" NPT
1/2" NPT pipe must extend
3/8" (1 cm) - 1/2" (1.3 cm)
beyond finished wall.
7-1/8"
(18.1 cm)
1/2" Hot
5-5/8"
(14.3 cm)
6-3/8"
(16.2 cm) D.
1/2" Cold
10" (25.4 cm)
4" (10.2 cm)
6-7/8" (17.5 cm)
2-3/4" (7 cm) Thin Wall
2-3/4" (7 cm) - 3-1/2" (8.9 cm)
Thick Wall
Top of The Rim
48" (121.9 cm)
to Floor
(Shower Only)
72" (182.9 cm) -
78" (198.1 cm)
to Floor (Typical)
2"
(5.1 cm)
4"
(10.2 cm)
2"
(5.1 cm)
4-3/8"
(11.1 cm)
Product Diagram
OBLO
®
RITE-TEMP
®
OBLO
®
RITE-TEMP
®
BATH/SHOWER VALVE TRIM
Page2of2
1091244-4-
C