Specification

Required Accessories
K-304-* Rite-Temp valve OR ❑ NA
K-2971-KS HiFlow Rite-Temp valve with stops ❑ NA
* For a complete listing of all the Rite-Temp valves, refer to the K-304-* Specification Sheet or Roughing-In sheet.
Optional Accessories
88526 HiFlow Rite-Temp
®
thin wall installation kit ❑ CP ❑ Other ____
1025388 Forte
®
deep roughing-in kit for Rite-Temp
®
valve (lever
handles)
❑ NA
Installation Notes
Install this product according to the installation guide.
Install the Rite-Temp
®
valve according to the valve installation
guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install straight pipe or tube drop of 7″ (17.8 cm) to 18″
(45.7 cm) with single elbow between valve and wall-mount
spout.
1/2"-14 NPT
6"
(15.2 cm)
72" (182.9 cm)
78" (198.1 cm)
to Floor (Typical)
2-7/8"
(7.3 cm)
Sculpted
Traditional
5-1/4" (13.3 cm)
Sculpted
5-1/4" (13.3 cm)
Traditional
48" (121.4 cm)
to Floor
(Shower Only)
6-3/8"
(16.2 cm)
10" (25.4 cm)
to Spout
(Bath Only)
Top of Bath
5-1/4" (13.3 cm)
4" (10.2 cm)
6"
(15.2 cm)
3"
(7.6 cm)
For slip-fit spout, tubing must
extend 2-1/8" (5.4 cm) Min;
3-1/2" (8.9 cm) Max beyond
finished wall.
For 1/2" NPT spout, pipe
must extend 4-1/2" (11.4 cm)
beyond finished wall.
Product Diagram
FORTE
®
RITE-TEMP
®
FORTE
®
RITE-TEMP
®
PRESSURE-BALANCING BATH AND SHOWER VALVE TRIM
Page2of2
1041824-4-
D