Installation Guide

4. Install the Escutcheon and Handle
CAUTION: Risk of product damage to the K-306-KS valve
assembly. When using this valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
NOTE: If the wall thickness is greater than 3/4″ (1.9 cm), use the
Deep Rough-in Kit (1025388) to add 3/4″ (1.9 cm) of depth to the
handle assembly.
Attach the trim adapter to the valve using the two supplied
screws.
Choose the proper stem adapter. If the wall thickness is less than
3/8″ (1 cm), use the short stem adapter and screw. If the wall
thickness is 3/8″ (1 cm) to 3/4″ (1.9 cm), use the long stem
adapter and screw.
Turn the valve stem counterclockwise to the ″off″ position.
Align the stem adapter with a flat side horizontal. If the stem
adapter is not properly aligned, the handle assembly will not
align properly. Reposition the stem adapter until the proper
position is achieved.
Attach the stem adapter with the appropriate screw.
Place the escutcheon on the bonnet.
Thread the bonnet on the trim adapter.
Discard
plaster guard
with dome.
Trim
Adapter
Stem
Adapter
Handle
Escutcheon
Screw
Bonnet
Screw
Valve
Stem Adapter should
be parallel to floor.
1036173-2-A 8 Kohler Co.