Rough-In Guide
Product Information
Applicable faucet trim:
Bath and shower trim with diverter –
plain cross handles, plain spout
K-T13133-3A
Bath and shower trim with diverter –
grooved cross handles, grooved
spout
K-T13133-3B
Bath and shower trim with diverter –
plain lever handles, plain spout
K-T13133-4A
Bath and shower trim with diverter –
grooved lever handles, grooved
spout
K-T13133-4B
Handles comply with the actuation
force Accessibility Guidelines
(Section 309 Operation) of the
Americans with Disabilities Act.
*Valve system required (not shown).
Required valve:
Rite-Temp
®
pressure-balancing valve with
push-button diverter
K-305-K
Rite-Temp
®
pressure-balancing valve with
push-button diverter and screwdriver stops
K-305-KS
Optional accessories:
Deep rough-in kit 73418
Installation Notes
Install this product according to the installation guide.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mount spout, diverter, or
handshower is connected to spout outlet.
Install straight pipe or tube drop of 7″ (17.8 cm) to 18″ (45.7
cm) with single elbow between valve and wall-mount spout.
6"
(15.2 cm)
3-1/4"
(8.3 cm)
48" (121.9 cm)
To Floor
(Shower Only)
4"
(10.2 cm)
10"
(25.4 cm)
To Spout
(Bath Only)
6-11/16" (17 cm)
6-7/8" (17.5 cm)
11-1/4"
(28.6 cm)
Max
3-1/4"
(8.3 cm)
Grooved
Cross Handle
Plain
Cross Handle
72" (182.9 cm) To
78" (198.1 cm) To
Floor (Typical)
Top Of
Bath
1/2"-14
NPT
6-15/16"
(17.6 cm)
3-7/8"
(9.8 cm)
3-7/8"
(9.8 cm)
Grooved
Lever Handle
Plain
Lever Handle
3"
(7.6 cm)
3"
(7.6 cm)
1/2" IPS
Roughing-In
K-T13133
PINSTRIPE
TM
BATH/SHOWER FAUCET TRIM
PINSTRIPETM BATH/SHOWER FAUCET TRIM
1036141-1-
C