Installation Guide

1. Install the Spout, If Used
Remove the temporary nipple.
Apply thread sealant and install a 1/2″ nipple so it extends 7/16″
(1.1 cm) beyond the finished wall.
Apply a bead of plumbers putty or other sealant around the back
of the escutcheon according to the manufacturer’s instructions.
Apply thread sealant to the nipple and thread the spout onto the
nipple.
Carefully tighten with a clean strap wrench.
Remove all excess putty.
Spout
Bath
Elbow
Escutcheon
Apply Thread
Sealant Tape.
Apply
Plumbers
Putty.
7/16"
(1.1 cm)
1/2" Nipple
1036140-2-A 4 Kohler Co.