Installation Guide

3. Install Handles
Remove the plaster guards from the hot and cold valves.
Check that the valve bodies have an adapter installed to fit the
bonnet threads.
Install the stem extensions over the valve stems.
If shipped loose, install the plastic spline adapters on the stem
extensions.
Apply a ring of plumbers putty or other sealant around the
underside of the bonnets according to the manufacturer’s
instructions.
Thread the bonnets onto the valve bodies until the bonnets
contact the deck.
NOTE: The stem extension allows fine adjustment of the handle
alignment. To adjust, remove the handle and reposition the
extension. Reinstall the handle and check the alignment. Repeat
until the handle alignment is satisfactory.
Locate the groove in the hole in the handles and orient the
groove to the bath.
Position the handles on the plastic spline adapters. Secure the
handles with the screws.
Orient the tab on the hot plug button with the groove in the
left-hand valve handle and push the plug button into the handle.
Apply
plumbers
putty to
bonnet.
Stem
Extension
Plastic Spline
Adapter
Valve
Body
Valve
Stem
Bonnet
Plastic Spline
Adapter
Tab
Bonnet
Groove
Stem Extension
Screw
Handle
Plug
Button
Kohler Co. 5 1036138-2-A