Specification

Optional Accessories
88526 HiFlow Rite-Temp thin wall installation kit ❑ CP ❑ Other ____
1073881 HiFlow Rite-Temp thick wall installation kit ❑ NA
Installation Notes
Install the valve trim according to the installation guide.
Install the Rite-Temp valve according to the installation guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install a shut-off device on
either valve outlet.
Cap the shower outlet if the deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install a 7″ (178 mm) to 18″ (457 mm) straight pipe or straight
tube with single bath elbow between the valve and the
wall-mount spout.
4" (102 mm)
to Top of Rim
6" (152 mm)
4-1/2"
(114 mm)
6-1/2"
(165 mm)
1/2" NPT
1/2" Hot
1/2" Cold
10" (254 mm)
to Spout
(Bath Only)
Ø 6-1/2"
(165 mm)
2-3/4" (70 mm) Thin Wall
3-1/2" (89 mm) Thick Wall
For slip-fit spout, 5/8" OD tube
must extend 5" (127 mm) beyond
finished wall.
For 1/2" NPT threaded spout, pipe
must extend 5" (127 mm)
beyond finished wall.
72" (1829 mm)-
78" (1981 mm)
to Floor (Typical)
48" (1219 mm)
to Floor
(Shower Only)
Product Diagram
KELSTON
®
RITE-TEMP
®
KELSTON
®
RITE-TEMP
®
BATH AND SHOWER VALVE TRIM
Page2of2
1178891-4-
A