Installation Guide

1. Install the Spout
IMPORTANT! Use care when installing the spout to avoid
scratching the finish.
Thread the spout into the spout shank until it is snug. If needed,
adjust the spout slightly to position it so it points straight down.
Secure the spout in place by tightening the flange with the screws
provided.
Confirm that the O-ring is inside the escutcheon.
Apply plumbers putty or other sealant to the back surface of the
spout escutcheon according to the putty manufacturer’s
instructions.
Carefully slide the spout escutcheon over the spout and press
firmly against the finished wall.
Remove any excess putty or sealant.
O-Ring
Screws
Escutcheon
Flange
Faucet Outlet
Port
Spout
Apply plumbers
putty.
Kohler Co. 3 1013994-2-C