Installation Guide

2. Installation on Finished Deck or Rim

NOTE: For installation on a rough (unﬁnished) deck, proceed to Installation

on Rough (Unﬁnished) Deck.

Use 1/2” nominal, 5/8” O.D. copper tubing. Cut two pieces of tubing to a

length of 2–7/8” (7.3cm). Cut one piece of tubing to a length of 2–3/8”

(6cm) for the spout supply.

IMPORTANT! Leave the protective sleeve on the spout supply tube until

the spout is installed to protect the O-ring sealing surface.

Install Spout Supply Tube

Slide a brass washer from the bottom of the spout supply tube over the

threads until the washer reaches the supply tube shoulder.

Insert the spout supply tube through the mounting hole from the top of the

deck/rim. Ensure that the ﬂat portion of the washer faces forward. The

supply tube will be suspended by the washer.

Slide a brass washer onto the spout supply tube from the bottom and

thread the mounting nut. Tighten the nut.

NOTE: Do not use the supplied wood screws for installation on ﬁnished

deck or rim.

Install Valve Bodies

Thread one mounting nut, ﬂange side up, onto each valve body.

NOTE: Rims less than 1/4” (6mm) thick require two rubber washers in the

following step; other installations require one rubber washer.

1” (2.5cm)

Collar

Hot Supply

Cold

Supply

Solder

2-7/8” (7.3cm)

Copper Tubes

Valve Body

Mounting Nut

Fiber Washer

Rubber Washer

or Washers

Spout Supply Tube

Supply Tube Shoulder

Brass W

ashers

Nut

Solder

2–3/8” (6cm)

Copper Tube

1/2” (1.3cm)

Tee

Solder

1016271-2-A 4 Kohler Co.