Installation Guide

Installation on Finished Deck or Rim (cont.)

Slide one ﬁber washer, followed by one or two rubber washers, onto each

valve body.

Insert the 2–7/8” (7.3cm) long copper tubes between the valve bodies and

the 1/2” tee. Insert the 2–3/8” (6cm) long copper tube into the top of the

tee.

Do not solder the connections at this time.

NOTE: The valve body marked “Cold” must be on the right side when you

are facing the front of the faucet.

Insert the valve bodies through the mounting holes from the bottom of the

deck/rim. Match the copper tube from the tee with the spout supply tube.

Hold in place.

Place a collar with the ﬂange side up, onto each valve body. Thread the

collar down to at least 1” (2.5cm) from the top thread on the valve body.

Tighten the mounting nuts on each valve body from underneath the

deck/rim.

Solder the copper tubes to the valve bodies, tee and spout supply tube.

Solder the hot and cold water tubes to the valve body inlets. Ensure that the

cold supply is on the right side.

Proceed to Check Operation of Valves.

Kohler Co. 5 1016271-2-A