Installation Guide

3. Installation on Rough (Unfinished) Deck
Use 1/2” nominal, 5/8” O.D. copper tubing. Cut two pieces of tubing to a
length of 2–7/8” (7.3cm). Cut one piece of tubing to a length of 2–3/8”
(6cm) for the spout supply.
IMPORTANT! Leave the protective sleeve on the spout supply tube until
the spout is installed to protect the O-ring sealing surface.
Install Spout Supply Tube
Slide a brass washer from the bottom of the spout supply tube over the
threads until the washer reaches the supply tube shoulder. Ensure that the
countersunk holes in the washer are facing upward.
Insert the spout supply tube through the mounting hole from the top of the
deck. Ensure that the flat portion of the washer faces forward. The supply
tube will be suspended by the washer.
Slide a brass washer onto the spout supply tube from the bottom and
thread the mounting nut. Tighten the nut.
Secure the brass washer to the deck using the two supplied wood screws.
Install Valve Bodies
Thread one mounting nut, flange side up, followed by one fiber washer and
one rubber washer onto each valve body.
Insert the 2–7/8” (7.3cm) long copper tubes between the valve bodies and
the 1/2” tee.
Do not solder the connections at this time.
1” (2.5cm)
Collar
Hot Supply
Cold
Supply
Solder
2-7/8” (7.3cm)
Copper Tubes
Valve Body
Mounting Nut
Fiber Washer
Rubber Washer
or Washers
Spout Supply Tube
Supply Tube
Shoulder
Brass Washers
Nut
Solder
2–3/8” (6cm)
Copper Tube
1/2” (1.3cm)
Tee
Solder
Screw
Screw
1016271-2-A 6 Kohler Co.