Specification

Required Accessories
K-304-* Rite-Temp
®
valve OR ❑ NA
K-2971-KS HiFlow Rite-Temp valve with stops OR ❑ NA
K-11748-K Rite-Temp valve with diverter OR ❑ NA
K-11748-KS Rite-Temp valve with diverter and stops ❑ NA
* For a complete listing of all the Rite-Temp valves, refer to the K-304-* Specification Sheet or Roughing-In Sheet.
Optional Accessories
88526 HiFlow Rite-Temp
®
thin wall installation kit ❑ CP ❑ Other_____
1030932 Deep roughing-in kit for Rite-Temp
®
valve (all handles) without diverter ❑ NA
1104834 Deep roughing-in kit for Rite-Temp valve (all handles) with diverter ❑ CP ❑ Other_____
Installation Notes
Install this product according to the installation guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mount spout, diverter, or
handshower is connected to spout outlet.
Install straight pipe or tube drop of 7″ (17.8 cm) to 18″
(45.7 cm) with single elbow between valve and wall-mount
spout.
1/2" Hot
1/2" Cold
4" (10.2 cm)
Without Stops
7" (17.8 cm)
With Stops
4"
(10.2 cm)
72" (182.9 cm) -
78" (198.1 cm)
Floor (Typical)
Top of Bath
2"
(5.1 cm)
4"
(10.2 cm)
2-3/4" (7 cm) -
3-1/2" (8.9 cm)
Thick Wall
2-3/4" (7 cm)
Thin Wall
1/2" - 14 NPT or 5/8"
ID for 1/2" Nom
Copper Tubing
1/2" - 14 NPT
1/2" - 14 NPT
3-1/8"
(7.9 cm)
9-1/8"
(23.2 cm)
3" (7.6 cm)
1" (2.5 cm)
3" (7.6 cm)
1" (2.5 cm)
6-1/2"
(16.5 cm) D.
10" (25.4 cm)
To Spout
(Bath Only)
48" (121.9 cm)
To Floor
(Shower Only)
5-3/4" (14.6 cm)
Traditional
Scroll
Product Diagram
REVIVAL
®
REVIVAL
®
BATH AND SHOWER FAUCET TRIM
Page2of2
1104832-4-
B