Installation Guide

1012557-2-A

Kohler Co., Kohler, WI U.S.A.

6. BEFORE INSTALLING SPOUT AND HANDLES

REMOVE PIPE PLUG

Ensure that the valves are closed (cold - fully

counterclockwise, hot - fully clockwise).

Turn off the main water supply.

1/4” Pipe Plug

Cold

Hot

WARNING: Risk of personal injury. Lines may be

pressurized. Do not lean over pipe plug when

turning or removing the plug.

Wrap a towel around the pipe plug to prevent water spray.

Water may purge from the supply tube when you remove

the plug.

Carefully remove the pipe plug.

Fig. #15

7. INSTALL SPOUT

Remove the plaster guard from the spout supply tube.

Cut off the spout supply tube 1-1/4” (3.2cm) above the rim,

finished deck, or tile.

Ensure that all burrs are removed from the supply tube to

prevent damage to the O-ring seal on the sleeve.

Fig. #16

1-1/4” (3.2cm)

Tile

Finish

Rough

Deck

NOTE: The following step is applicable to a tile covered

rough deck installation only.

Slide a brass washer, flat side facing forward, onto the

supply tube. The brass washer is furnished with the spout.

NOTE: The washer is not needed for rim/finished deck

installation.

Fig. #17

Spout

Supply

Tube

Rough

Deck

Finished

Deck

Washer