Installation Guide

1012557-2-A

Kohler Co., Kohler, WI U.S.A.

Back off the setscrews in the sleeve, and with a twisting

motion install the sleeve on the spout supply tube until it

contacts the washer surface.

Align the sleeve so the setscrews are not facing directly

forward or backward.

Tighten the setscrews.

When supplied, position the ring over the sleeve so it rests

upon the washer.

Fig. #18

Setscrew

Sleeve

Apply a ring of plumbers putty or other sealant around the

underside of the spout according to the putty

manufacturer’s instructions.

Fig. #19

Spout

Apply Plumbers Putty

CAUTION: Risk of product damage. Use care

when installing the spout assembly to prevent

damage to the O-ring seal on the sleeve.

Install the spout assembly onto the sleeve, and carefully

press down until the spout base contacts the deck, rim, or

tile.

Align the spout as desired, and tighten the setscrew.

If included, press the plug button into the setscrew hole.

Fig. #20

Setscrew

Plug

Button