Installation Guide

2. Spout Orientation
NOTE: Verify correct spout orientation before securing the base to
the wooden support.
NOTE: The base has a blue mark and a notch on the cold supply
side.
Orient the base with the cold supply side notch placed in the
direction shown.
If possible, dry fit the faucet to the base using the screws and
washers. Orient the spout to the inside of the bath.
If your faucet is not available at this time, make sure the base is
positioned so water from the spout will properly flow into the
bath.
Mark the mounting hole locations on the wooden support.
Mark the orientation of the base, and where the notch is
positioned on the wooden support.
Cold
Bath
Hot
Pencil
Wall
Top View
Base
Kohler Co. 5 1246878-2-A