Installation Guide

2. Install the Spout Supply Tube
Remove the plaster guard from the spout supply tube.
Using a tube cutter, cut the spout supply tube 1-1/4″ (3.2 cm)
above the finished surface.
Using a file, remove all burrs from the spout supply tube. This
will prevent damage to the O-ring inside the sleeve.
For tile-covered deck installations: Slide the brass washer
(provided) onto the spout supply tube with the flat side facing
forward. For all other installations: Discard the brass washer.
Loosen the screws in the sleeve.
Using a twisting motion, slide the sleeve onto the spout supply
tube until it contacts the finished surface.
Align the sleeve with the screws offset from the center (not facing
directly forward or backward), as shown.
Retighten the screws.
1-1/4" (3.2 cm)
For Tile-Covered Deck
Installation
Install
Sleeve
Sleeve
Screws
Spout Supply Tube
Brass Washer
Install Spout Supply Tube
Spout
Supply
Tube
Finished
Deck
1011303-2-C 4 Kohler Co.