Instructions / Assembly

6. Install the Faucet
NOTICE: To avoid damage to the O-rings on the bottom of the
faucet, keep the faucet vertical and use care when installing the
faucet.
Make sure the water is turned off.
Relieve the water pressure.
Remove the plug from the base.
Remove the rubber protector (not shown) from the faucet.
Place the faucet onto the base and insert the screws and washers
provided through the flange.
Tighten the screws using the hex wrench provided.
Slide the escutcheon down onto the floor, covering the base.
Washer
Base
Plug
O-Rings
Flange
Screw
Hex
Wrench
Escutcheon
1240535-2-D 10 Kohler Co.