Rough In Guide

Product Information
Applicable product:
Custom bath whirlpool – drop-in K-1239-CB
Fixture*:
Bathing well:
Basin area, bottom 46″ (1168 mm) x 24″ (610 mm)
Basin area, top 54″ (1372 mm) x 27″ (686 mm)
Weight 105 lbs (47.6 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 63 gal (238.5 L)
* Approximate measurements for comparison only.
Drop-in cutout: 58″ (1473 mm) x 34″ (864 mm)
Pump: V Hz A
1-speed 120 60 7.5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Locate the outlet behind the whirlpool and within 24″
(610 mm) of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
44 lbs/square foot (214 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. If installing a spout on the faucet
deck, consult local and national codes for minimum air gap
requirements.
The apron must be installed before the finished floor and wall
materials are installed.
Pump must be relocated to custom position at the time of
installation. Provide adequate clearance.
Fixture conforms to CSA B45.5/IAPMO Z124. All dimensions
are nominal.
7-1/2"
(191 mm) Max
18-1/2"
(470 mm)
20"
(508 mm)
8-11/16" (221 mm)
1-11/16"
(43 mm)
3"
(76 mm)
2-7/8"
(73 mm)
1" (25 mm)
3-1/2"
(89 mm)
18"
(457 mm)
60" (1524 mm)
1-1/2" OD
36" (914 mm)
1-1/2"
(38 mm)
Drop-in Rim
Detail
No change in measurements if connected with drain
illustrated. (K-7161-AF or K-7161M-AF)
Pump/Control
Access
20" (508 mm) W x
15" (381 mm) H
Recommended Faucet Area
Roughing-In
K-1239-CB
MARIPOSA
®
CUSTOM BATH WHIRLPOOL
MARIPOSA
®
CUSTOM BATH WHIRLPOOL
1014713-1-
D