Rough In Guide

Product Information
Applicable products:
5’ Bubblemassage bath – left drain K-1357-GLA
5’ Bubblemassage bath – right drain K-1357-GRA
Fixture*:
Bathing well:
Basin area, bottom 42″ (106.7 cm) x 20″ (50.8 cm)
Basin area, top 51″ (129.5 cm) x 24″ (61 cm)
Weight 98 lbs (44.5 kg)
To overflow:
Water depth 14-1/2″ (36.8 cm)
Capacity 60 gal (227.1 L)
* Approximate measurements for comparison only.
Blower motor: Heater V Hz A
300 W 120 60 5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (61 cm)
grounding-type plug-in cord.
Installation Notes
NOTICE: If the blower motor and check valve are
relocated, the following two procedures are required: 1.
Provide two access panels. Locate one access panel at the
blower motor/control location and the other access panel at
the control box. 2. Relocate the blower motor and the check
valve together. Do not relocate one without the other.
Install this product according to the installation guide.
Floor support under the bath must provide for a minimum of
47 lbs/square foot (229 kg/square meter) loading.
Fixture dimensions are nominal and conform to tolerances in
ANSI Standard Z124.1.2.
32" (81.3 cm)
60" (152.4 cm)
2-1/2"
(6.4 cm)
1-1/2" OD
20"
(50.8 cm)
21-1/4"
(54 cm)
1" (2.5 cm)
2-1/4"
(5.7 cm)
9" (22.9 cm)
3"
(7.6 cm)
16"
(40.6 cm)
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
Integral Flange Detail
1-1/4"
(3.2 cm)
1/2"
(1.3 cm) R.
Roughing-In
K-1357-GLA, K-1357-GRA
DEVONSHIRE
®
5’ BUBBLEMASSAGETM BATH
DEVONSHIRE
®
5’ BUBBLEMASSAGETM BATH
1040137-1-
C