Installation and Care Guide

Instale el codo de desagüe
NOTA: Retire las rebabas que puedan existir en la salida del desagüe de la bañera.
Extraiga el obturador de la coladera.
Desensamble la coladera y el empaque del codo del desagüe.
Aplique una tira de masilla de plomería u otro sellador alrededor del lado inferior
de la coladera. Consulte las instrucciones del fabricante de la masilla de plomería
o sellador.
Coloque el empaque entre el codo del desagüe y la parte inferior de la salida del
desagüe de la bañera.
Enrosque la coladera en el codo de desagüe hasta que quede ajustada. No apriete
la coladera completamente en este momento.
2. Secure the Overflow Ell
Position the tapered gasket with the tapered side against the overflow ell and the
thin edge of the gasket at the top of the overflow ell, as shown.
Attach the tapered gasket in this position on the overflow ell.
Lubricate each o-ring, then slide each o-ring onto each groove of the overflow ell.
Align the overflow ell with the overflow hole of the bath.
Align the retainer plate over the lower mounting holes on the overflow ell.
From inside the bath, insert the two flathead screws through the retainer plate and
into the mounting holes on the overflow ell.
O-Ring
Joint torique
Arosello
Tapered Gasket
Joint conique
Empaque cónico
Overflow Ell
Coude du trop-plein
Codo del rebosadero
Retainer Plate
Plaque de retenue
Placa de retención
Screws
Vis
Tornillos
Kohler Co. 7 1101880-2-B