User Manual

JOBNAME: No Job Name PAGE: 5 SESS: 3 OUTPUT: Tue Apr 27 20:27:06 2010
Remote Control Compliance (cont.)
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Warning
This portable transmitter with its antenna complies with FCC’s RF exposure limits for general
population/uncontrolled exposure.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
CANADA IC: 4554A-KOHLER001
Industry Canada Statement per Section 4.0 of RSP-100
The term ″IC:″ before the certification/registration number only signifies that the Industry Canada technical
specifications were met.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the
device.
Section 2.6 of RSS-102
This portable transmitter with its antenna complies with Industry Canada RF Exposure Limits for General
Population/Uncontrolled Exposure.
Modifications: any modifications mad to this device that are not approved by Kohler Co. may void the
authority granted to the user by the FCC to operate this equipment.
This Class B digital apparatus complies with Canadian ICES-003.
Troubleshooting Information
NOTE: When the remote is not in use, it will fall into standby mode after 3 minutes (6 minutes if the front
or rear wash has ever been activated). Press the wake-up key at the top of the remote control screen to
activate the remote.
NOTE: If the back light in the window is off, the first touch on the remote screen activates the light. The
second touch activates the function.
Start-up
When the toilet is first installed or the power fails, when power is restored or turned on the toilet
will automatically go into start-up mode.
If the toilet does not function correctly upon completing the start-up sequence, or it fails to start,
contact customer service using the numbers located on the back page of this manual.
Kohler Co. 5 1132336-5-A
More information will be added.