User's Manual

JOBNAME: No Job Name PAGE: 16 SESS: 17 OUTPUT: Wed Apr 6 16:10:51 2016
Troubleshooting Information (cont.)
Symptoms Probable Causes Recommended Action
5. Water stops flowing from
the spray wand before
you are finished
cleansing.
A. Five minutes after pressing one
of the spray icons, washing
automatically stops.
A. Press the ″Rear″ or ″Front″ icon
again.
6. Deodorizer feature is not
working.
A. The deodorizer is not activated. A. Activate the deodorizer feature
using the remote control.
7. UV sterilization feature is
not working.
A. The UV sterilization is not
activated.
A. Activate the UV sterilization
feature using the remote control.
8. The toilet does not flush
automatically.
A. Automatic flush feature is not
enabled.
A1. Activate the automatic flush feature
using the remote control.
A2. The sensor did not detect the user.
If this issue occurs repeatedly, call
the Customer Care Center using
the information provided on the
back page of this manual.
9. The night light does not
turn on in low light
conditions.
A. Night light is not enabled. A. Enable the night light feature using
the remote control.
B. Low light sensor is not working
properly.
B1. Clean the light sensor located on
the manual control panel.
B2. Call the Customer Care Center
using the information provided on
the back page of this manual.
Remote Control
Symptoms Probable Causes Recommended Action
1. The remote control is not
turning on.
A. The batteries are not correctly
installed.
A. Remove and reinstall the batteries.
B. The batteries are drained. B1. Replace the batteries.
B2. Call the Customer Care Center
using the information provided on
the back page of this manual.
2. The remote control is not
connecting with the toilet.
A. The remote is too far from the
toilet to receive signal.
A. Move the remote closer to the toilet
to regain connection.
Remote Control Compliance
FCC ID: N82-KOHLER015, N82-KOHLER018
IFT: Certification Number RCPKO1215-2233 and RCPKO1215-2234.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
1247364-5-A 16 Kohler Co.