Owner's Guide

Remote Control - Setup

NOTE: The remote control must be charged to operate. The ″stop″ icon will blink when the remote needs

to be charged.

Charging the Remote

Verify that the docking station has batteries installed. Refer to the ″Replacing the Batteries″ section.

Place the remote control on docking station.

The remote is adequately charged when the ″stop″ icon stops blinking.

Pairing to the Toilet

IMPORTANT! The remote control cannot be paired to the toilet while the toilet is occupied.

NOTE: The icons on the bottom row of the remote control will ﬂash when the remote is not paired or is

out of range of the toilet.

Press the power button to turn on the remote control.

Move the remote control within close proximity to the toilet. The bottom row of icons should be

ﬂashing.

Press and hold the ″dryer″ icon on the remote control.

While holding the ″dryer″ icon on the remote control, press and hold the Front Wash and Rear

Wash icons simultaneously on the toilet control panel. Release after a short beep is heard.

When pairing is successful, the bottom icons will stop ﬂashing.

Power Button

Docking Station

Control Panel

Front

Wash

Rear

Wash

Kohler Co. 5 1295780-5-A

PROOF