Rough In Guide

Product Information
Applicable product:
Shower only trim with biscuit accents K-T313-4F
Shower only trim with polished finish
accents
K-T313-4M
Shower only trim with white accents K-T313-4P
Valve only trim with biscuit accents K-T309-4F
Valve only trim with polished finish
accents
K-T309-4M
Valve only trim with white accents K-T309-4P
Required accessories:
Rite-Temp
®
valve without stops OR K-304-*
HiFlow Rite-Temp valve with stops K-2971-KS
* For a complete listing of all the RiteTemp valves, refer
to the K-304-* Specification Sheet or Roughing-In Sheet.
Optional accessories:
HiFlow Rite-Temp
®
thin wall installation
kit
88526
Installation Notes
Install this product according to the installation guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mount spout, diverter, or
handshower is connected to spout outlet.
Install straight pipe or tube drop of 7″ (17.8 cm) to 18″ (45.7
cm) with single elbow between valve and wall-mount spout
1/2"-14 NPT
9" (22.9 cm)
2-3/4"
(7 cm)
72" (182.9 cm) to
78" (198.1 cm)
Floor (typical)
13/16"
(2.1 cm)
6-1/4"
(15.9 cm) D.
48" (121.9 cm) to Floor
(Shower Only)
3-13/16"
(9.7 cm)
Roughing-In
K-T313, K-T309
FINIAL
®
TRADITIONAL
SHOWER FAUCET TRIM
FINIAL
®
TRADITIONAL SHOWER FAUCET TRIM
1023659-1-
C