Installation & Assembly

4. Install the Insert
IMPORTANT! The tiled insert is heavy. Install with two people.
Ensure that the sink pocket edge is protected by the provided
plastic clips, or equivalent.
Carefully lift the insert into the pocket. Slide the insert as far back
as it will go. The insert should be slightly recessed from the front
face of the sink.
Center the insert left-to-right in the pocket.
Place a lock washer on one bolt. While pushing the insert into the
pocket, slide the bolt through one of the holes in the bottom of
the apron. The bolt must engage the threads at the top of the
pocket.
Confirm that the insert is centered in the pocket. If adjustment is
necessary, go back to the ″Prepare the Insert″ section.
Insert the second bolt and lock washer so that the threads are
engaged.
Securely tighten both bolts with the provided 5 mm hex wrench.
1368040-2-A 6 Kohler Co.