Installation & Assembly

1. Install the Wall Jamb
IMPORTANT! Install the wall jamb on the same side wall as the showerhead.
NOTE: Remove the trim cap from the wall jamb before beginning installation.
Position the wall jamb against the wall, on the highest point of the bath or shower base ledge. Refer
to the illustration above for correct placement.
If needed, use a coin to match and mark the corner radius on the bottom of the wall jamb that fits
against the shower base and wall.
Trim the wall jamb to fit the shower base.
Use a file to remove any burrs.
Use a level to verify that the wall jamb is plumb.
Temporarily secure the wall jamb with masking tape.
Mark the four hole locations on the wall jamb.
Remove the masking tape and set the wall jamb aside.
IMPORTANT! A 1/4″ drill bit is not suitable for drilling through tile. For tile installations, use a 1/4″ tile
bit.
Drill a 1/4″ hole at each of the four marked hole locations.
Insert an anchor into each hole. Verify that the anchors are flush with the finished wall.
Secure the wall jamb with the provided screws.
Apply 100% silicone sealant to the bottom inside of the wall jamb.
Ledge
Wall Jamb
Ø 1/4"
Kohler Co. 3 1284425-2-C