RDT Transfer Switch Manual

ManualsBrandsKohler ManualsAutomaticRDT Series 400-Amp Outdoor Automatic Transfer Switch

TP-6345 9/13 7Introduction

Introduction

This manual provides operation and installation

instructions for Kohler Model RDT automatic transfer

switches with MPACr 500 electrical controls.

Information in this publication represents data available

at the time of print. Kohler Co. reserves the right to

change this literature and the products represented

without notice and without any obligation or liability

whatsoever.

Read this manual and carefully follow all procedures

and safety precautions to ensure proper equipment

operation and to avoid bodily injury. Read and follow the

Safety Precautions and Instructions section at the

beginning of this manual. Keep this manual with the

equipment for future reference.

The equipment service requirements are very important

to safe and efficient operation. Inspect parts often and

perform required service at the prescribed intervals.

Obtain service from an authorized service distributor/

dealer to keep equipment in top condition.

Nameplate

A nameplate attached to the inside of the enclosure

cover includes a model designation, a serial number,

ratings, and other information about the transfer switch.

SeeFigure1.

Check the transfer switch model number from the

transfer switch nameplate and verify that it matches the

model shown on the front cover of this manual before

proceeding with installation.

Copy the model designation, serial number, and

accessory information from the nameplate to the spaces

provided in the Product Identification Information

section located inside the front cover of this manual for

use when requesting service or parts. Copy the model

designation into the spaces in the Model Code chart and

use the chart to interpret the model designation.

TRANSFER SWITCH

GM21291-E

1. Model designation

2. Serial number

3. Factory-installed accessory numbers

MATERIAL

FOR EMERGENCY SYSTEMS

TRANSFER SWITCH

TYPE ENCLOSURE

MFG. DATE

POLES

WIRES

AMPS

HERTZ

BAR CODE

PHASE

VOLTS

SERIAL NO.

MODEL

ACCESSORIES:

FOR EMERGENCY SYSTEMS

LISTED

Figure 1 Typical Transfer Switch Nameplate