RXT Transfer Switch Manual

TP-6807 1/16 7Introduction
Introduction
This manual provides operation and installation
instructions for Kohlerr Model RXT automatic transfer
switches. See Figure 2 for typical Model RXT transfer
switches.
Model RXT transfer switches operate only with Kohlerr
generator sets equipped with the RDC2 or DC2
generator/transfer switch controller. See Figure 1 or
Figure 3 for controller identification. The transfer switch
is equipped with either a standard interface board or a
combined interface/load management board. The
interface board communicates with the RDC2 or DC2
controller on the generator set.
Information in this publication represents data available
at the time of print. Kohler Co. reserves the right to
change this literature and the products represented
without notice and without any obligation or liability
whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section at the
beginning of this manual. Keep this manual with the
equipment for future reference.
The equipment service requirements are very important
to safe and efficient operation. Inspect parts often and
perform required service at the prescribed intervals.
Obtain service from an authorized service distributor/
dealer to keep equipment in top condition.
GM77569
RDC2 DC2
Figure 1 Original (green-board) RDC2 and DC2
Generator/ Transfer Switch Controllers
(mounted on the generator set)
Figure 2 Typical Model RXT Transfer Switches
(shown with optional status indicators)
RDC2 DC2
GM89864
Figure 3 Revised (red-board) RDC2 and DC2
Generator/ Transfer Switch Controllers
(mounted on the generator set)