Installation Guide

7. Install Spout
Wrap a towel around the pipe plug and carefully remove it.
Remove the plaster guard from the spout supply tube.
Cut off the spout supply tube 1–1/4” (3.2cm) above the rim, finished
deck or tile.
Ensure that all burrs are removed from the supply tube.
NOTE: If your installation is on a tile-covered rough deck, slide a
brass washer, flat side facing forward, onto the supply tube. The
brass washer is supplied with the spout. This washer is not needed
for rim/finished deck installations.
Loosen the setscrews in the sleeve. Use a twisting motion to install
the sleeve on the spout supply tube until it contacts the washer.
Align the sleeve so the setscrews are not facing directly forward or
backward and tighten the setscrews.
CAUTION: Risk of product damage. Use care when installing
the spout to prevent damage to the O-ring seal on the sleeve.
Install the spout onto the sleeve and carefully press down until the
spout base contacts the finished deck surface.
Align the spout and tighten the setscrew. If included, press the plug
button into the setscrew hole.
Kohler Co. 13 1017937-2-A